Lights Panel with self returning start switch

The lights panel could be a really easy panel but there are these self returning start switches integrated. There are different ways to build these. Some builders use solenoid switches and others use a servo motor which was also the way I have choosen.

Because the room behind this panel is very small, I couldn't build my backlighting panel as I always did it and it had to be mounted on the backside of the overhead frame of this section.

Used materials:

  • 3mm transparent and white acrylic
  • 11 big ON-OFF switches
  • 2 big ON-OFF-ON switches
  • 1 small ON-OFF-MOM switch
  • 2 12-position rotary switches
  • LED stripes for backlighting mounted on a HDF plate
  • 3mm HDF plate
  • 2 servo motors
  • 2 springs

In the download file you will find all the needed files to cut out and engrave your own panel as well as the new 3D files for the light switches and the start switches.

This entry was posted in Overhead. Bookmark the permalink.

4 Responses to Lights Panel with self returning start switch

  1. EurowingsFan099 says:

    Hello sir, why are you saying that you can download the blueprints and files on this side, but you actually have to buy it for 45€. Its kind of misleading because “download” and “can be found” sounds like its free. It would be better if you change the discription on the YT videos to like “you can buy all files and blueprints on my webside” So everyone knows its payed.

  2. Miguel says:

    Hello Mike,
    I have a question, to power the LEDs of the annunciators in the overhead, do you only use the current from the arduino board or do you have an external power supply? can you give me some info for the installation of the leds? can you tell me what resistance value you use to power the leds

    Thank you.

    • Mickey says:

      I power the LEDs just from the arduino. The installation is shown in detail in my video #37 where I build the annunciators. The value of the resitsor depends on the LED you are using. In my case I use 100 or 150 ohm resistors depending on the color. You find the needed values in my connection sheet which is free to download on my download page.

Leave a Reply to Mickey Cancel reply

Your email address will not be published. Required fields are marked *