Pressurisation Panel

This section of the overhead panel uses all the techniques learned from my single and duale needle gauge videos. In addition to the two gauges there is only one push button needed. This makes this panel relatively easy to build when you know how to construct these gauges.

The amount of different parts to cut out and engrave can be frightening. But find your way through all the construction steps and you will be rewarded with a big and nice looking gauge panel.

Materials used:

  • 3mm transparent and white acrylic
  • 1 push button
  • 2 15 mm hex standoffs
  • 8 30 mm female hex standoffs
  • 8 30 mm male hex standoffs
  • LED stripes for backlighting mounted on a HDF plate
  • 3mm HDF plate
  • 3 servo motors
  • 4 mm acrylic rod
  • 7 mm acrylic tube

The download package contains all the files you need to cut out and engrave your own panel as well as the gauges.

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *